12-07-2019, 05:30 PM
I got my first nils 8" 10 years ago. At first I wasn't careful with it and dulled it. It would not cut butter, so I Sent it back east at a cost of around $50 with shipping. And then I seen an advertisement for the Work Sharp knife sharpener. It comes with the jigs for different knifes, however with no jig on it it gives you a great little belt that has different grits and it works good on my nils to get the edge back razor sharp.
I have a question about the 5" hole. I just bought the 6" nils combo hand drill. Is it hard to get big trout up through that 5" hole?
[signature]
I have a question about the 5" hole. I just bought the 6" nils combo hand drill. Is it hard to get big trout up through that 5" hole?
[signature]