Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
Working with wire
#11
I was kind of wondering about a cross between your whirly fligs and the walleye harness... I love that interchangeable blade deal, now if I picked the right color flig body and had a walleye blade on it I might have something else to try...

Been dreaming of some way to do better on Cutler cats while trolling... In the past the s-turns in my toon worked pretty well, but I haven't done well from my boat at all... So I'm wondering if a side planer with my fligs trolled out to the side might help me start to catch them again... It's so shallow, I'm sure the boat is scaring the fish away from it, since the motor probably almost hits the fish... but I'm not sure I can get the new boat into the shallows where I have been catching them in the toon... Too bad my toon has to be licensed, and take so long to get ready to go and clean up... I like the boat because it doesn't take a lot of time to get on and off the water... I guess by not needing waders and rigging up everything for each trip it gives me more fishing time... Plus I can get to other spots a lot more quickly too... but it's sure hard to beat the finesse of the toon... time and place for both of them for sure... Later Jeff
When things get stressful think I'll go fish'en and worry about it tomorrow!
Reply


Messages In This Thread
Working with wire - by TubeDude - 02-16-2022, 08:31 PM
RE: Working with wire - by SkunkedAgain - 02-17-2022, 01:24 PM
RE: Working with wire - by TubeDude - 02-17-2022, 01:43 PM
RE: Working with wire - by Gone Forever - 02-17-2022, 11:04 PM
RE: Working with wire - by Cowboypirate - 02-17-2022, 01:44 PM
RE: Working with wire - by TubeDude - 02-17-2022, 01:48 PM
RE: Working with wire - by Bduck - 02-17-2022, 02:17 PM
RE: Working with wire - by TubeDude - 02-17-2022, 02:58 PM
RE: Working with wire - by SkunkedAgain - 02-17-2022, 03:04 PM
RE: Working with wire - by TubeDude - 02-17-2022, 04:02 PM
RE: Working with wire - by jjannie - 02-17-2022, 03:49 PM
RE: Working with wire - by SkunkedAgain - 02-17-2022, 05:50 PM
RE: Working with wire - by TubeDude - 02-17-2022, 07:00 PM
RE: Working with wire - by SkunkedAgain - 02-17-2022, 07:28 PM
RE: Working with wire - by TubeDude - 02-17-2022, 07:54 PM
RE: Working with wire - by SkunkedAgain - 02-17-2022, 09:26 PM
RE: Working with wire - by SkunkedAgain - 02-18-2022, 01:47 PM
RE: Working with wire - by TubeDude - 02-18-2022, 03:07 PM
RE: Working with wire - by SkunkedAgain - 02-18-2022, 04:03 PM

Forum Jump:


Users browsing this thread: 1 Guest(s)