04-20-2011, 03:47 AM
Well I figured that I would chime in, since everybody else has, I will start with my transducer setup. I started with a pvc T that fit over the tubing that my toon is constructed from,I had to use sandpaper just a little to enlarge the inside diameter enough to fit, then slipped over the cross member of my toon frame. From there a bushing down to 1/2 inch with a union, a 90 down to the needed length, and attached the transducer with machine screws.( Hopefully the pics show it ) With a quick twist of the wrist I can raise or lower it into position, and it stores well out of the way. For the monitor I have used a Panavise ( Google it) pretty much like a Ram mount but cheaper. I also used the Panavise and pvc for my rod holders. I posted pics of these a while back. I know this would not work for everyone, but it does work well for me. I only have time tonight for a couple of pics, but if anyone is interested let me know and I can get more later.
[signature]
[signature]