Tilt issue on Evinrude motor

[Bduck]

Looks like it's 1 inch between each hole on the ram.

Glad to hear you were able to get the servicing port screw removed. After servicing pump did it appear to work better than what it did? Without straining noise? The measurement on either of my tools is over 1". Were you able to call Marine Tech about the right tool?

---

I did a compatibility check; it appears that the tools I have will fit some motors including Evinrude E & Etech series. This link verifies that my wrenches fit MOST Evinrude tilt/trim pumps.
Johnson Evinrude Trim Tilt Wrenches - Built to Last with Lifetime Warranty - Removes Trim, Tilt, Steering Caps Fast & Easy (marinetech.com)
 

Our 3 Wrench Set Covers All [b]Yamaha, Honda, Suzuki, Johnston and Evenrude [/b]Trim and Tilt ends caps.  
Check compatibility chart on each pin wrench page for compatability,
If in doubt: MEASURE YOUR ENDCAPS. = Dimensions are distance ACROSS the cap NOT the two closest holes