Fishing Forum › Float Tube Fishing › Float Tubing General v
My FC4 rigging design

Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
Thread Modes
My FC4 rigging design
AdictedBassTard Offline
Rainbow Trout
*****
Posts: 312
Threads: 0
Joined: Dec 2005
Reputation: 0
#18
01-21-2006, 04:37 PM
After making a scale model (all the important measurements) of my FC4, I tested the rigging. I found the third rib was unnecessary, which is a good thing for simplification purposes. I then dumped the model (with correct unit weight, load points etc.) into a water simulation and loaded the cat with 220lb and the rigging @ 10lb. This is what i got. Accuracy projection is 98.3 %.
Whatcha folks think of this simplified version?

[Image: FC4gear.jpg]

-ABT-
[signature]
Find
Reply


Messages In This Thread
My FC4 rigging design - by AdictedBassTard - 01-18-2006, 10:23 PM
Re: [AdictedBassTard] My FC4 rigging design - by AdictedBassTard - 01-21-2006, 04:37 PM

Forum Jump:


Users browsing this thread: 2 Guest(s)