08-25-2003, 10:39 PM
[font "Times New Roman"][size 3]You can make your own rod case from a 3" pvc pipe, a end cap, two pieces of foam for end caps and a screw on cap. Glue on the foam end pieces before gluing on the end cap. Drill a small air hole in container to allow for air pressure release. For further protection make yourself a cloth bag to put your rod in before placing in the case.[/size][/font]
[font "Times New Roman"][size 3] I use a couple clamps to mount one to the roof rack on my jeep .The rods are safe from breakage going back and forth .[/size][/font]
[font "Times New Roman"][size 3]A small key lock can be mounted inside the end cap and a notch inside the tube wall for "some" saftey . but i leave the extra rods locked inside the car . the empty tube is easy to replace , the rods aren't .[/size][/font]
[signature]
[font "Times New Roman"][size 3] I use a couple clamps to mount one to the roof rack on my jeep .The rods are safe from breakage going back and forth .[/size][/font]
[font "Times New Roman"][size 3]A small key lock can be mounted inside the end cap and a notch inside the tube wall for "some" saftey . but i leave the extra rods locked inside the car . the empty tube is easy to replace , the rods aren't .[/size][/font]
[signature]