Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
25 Tips for Saltwater Fishing
#1
Tough Knot
The Bimini Twist (also known as the Twenty-Times-Around knot) is the only knot that maintains 100 percent strength under all conditions. Use it to double the line for a strong leader connection.

Lures That Look New and Bright
Fish bite best on lures that look new and bright. Buy only lures you know you will need, and buy just enough to last a few trips. Rinse used lures and dry them before returning them to the tackle box.

Cut Back that Front Part
Change monofilament often. Once it begins to look dull or feel rough, it is no longer strong. At the very least, cut back that front part of the line to remove the weaker section, then retie the leader.

Soak It In a Bucket
Before storing a reel for any length of time, soak it in a bucket of fresh water for several hours to get all of the saltwater out of the line and the interior corners of the reel.

Big Fish With Rough Lips
Big fish with rough lips require extra-heavy monofilament. It takes 80- to 100-pound test to land 100-pound tarpon, or 50 to 80 to land a really big snook. But casting a long length of that stuff is difficult, so divide the leader into two stages. Keep the heavy stuff short -- 12 to 20 inches, for example -- and use lighter (e.g., 30- to 40-pound-test) for the secondary section that is essential when fishing around heavy cover or structure.

Set The Hook
Many anglers set the hook before the fish has the bait or lure well inside its mouth. Better to wait an extra second or two if you cannot see the fish, or wait until you actually see the bait or lure disappear inside the fish's mouth. A good way to time this is to wait until you feel a lot of pressure on the line from the fish.

Understanding Tidal Currents
Understanding tidal currents and how they affect the areas you fish is critical, because the movement of water does not always precisely follow high and low tides. In many spots, especially inlets and channel entrances, the tidal current may lag the actual tide by an hour or more. In areas like this, fish often respond more to the direction and speed of water movement than to the actual height of the tide. But in open water the height of the tide can be most important.

Marine Charts
You'll find fish in places where food is readily available. The mouth of a creek, channel, inlet, or estuary during falling tide is a prime example. Structure of almost any type is another. Marine charts and maps are indispensable for locating such potential hotspots.

Noisy Lures
When fishing turbid water, try noisy topwater lures. Lures with a rattle or pop worked slowly are easy for the fish to locate. Smaller is sometimes best on calm days, but bigger is better in choppy water.

Quick Sinking
Gel braid lines are more sensitive than monofilament. They also have a smaller diameter that offers less resistance in current, which makes them an excellent choice for fishing lures that sink quickly, especially jigs. They have become very popular with heavy jigs in extremely deep water. Some anglers fish them in depths in excess of 300 feet.

Lubricate a New Reel
Lubricate a new reel to make sure no critical areas were overlooked at the factory. Lube it again at the end of the fishing season or every six months if you fish throughout the year. Baitcasting reels may need a touch on the levelwind gears more often. Always use light oil in those areas where grease is not required.

Use What You Know
Use only brands of fishing line that you are familiar and comfortable with. Unknown bargain lines will often let you down at the worst moment.

Don't use a Wire Leader
Don't use a wire leader if you can get by with monofilament. You will get more strikes this way. Wire also kinks easily, which may cause it to break. Even toothy fish like Spanish mackerel and bluefish can be caught on mono leaders if the material is heavy enough (at least 50- or 60-pound-test), and if you cut back the mono whenever it begins to look gnawed.

Skip the Swivel
If you must use a wire leader, skip the swivel if possible. Make a loop in the wire with a Haywire Twist, and tie the doubled mono to the wire loop with an Albright knot.

Larger Diameter Line
The Connector knot is the best way to attach a larger diameter line to a smaller one because it slips through guides easily.

Circle Hooks
Hook sizes and shapes are critical with all types of bait. Circle hooks, for instance, are popular because they very rarely hook fish in the throat, and their hookup rate is as good or better than the conventional J-hook. Treble hooks are a poor choice for baitfishing since they are easily swallowed and do far more damage than when attached to a lure. Any fish that escapes with a treble hook in the throat is a dead fish.

Live Bait Stays in Top Condition
Live bait stays in top condition longer if kept in a well with good circulation. Incoming water is always best, but if that's not possible, use an aerator. Warm water cannot hold as much oxygen as cool, so temperature is critical. In an aerated, noncirculating system, the water must be changed every few hours to remove waste material that replaces oxygen in the water.

Lures Work Better
Most lures work better if attached to the line or leader with a loop knot. This allows a more natural action for bait as well..

Feel It Move
A fish that appears tired and lethargic needs some help. If you simply toss it back in the water, it will likely sink and die. Moving it back and forth in still water or facing it upstream in current will get its respiratory system back in operation a lot faster. Wait until you can feel the fish beginning to move on its own before letting it go.

Shrimp Crabs and Curstaceans
Shrimp, crabs, and other crustaceans can be kept alive and healthy for many hours in an ice chest if they are packed in wet newspaper or damp vegetation so they do not make direct contact with the ice or ice water.

Three Ingredients for Chumming
Chumming requires three ingredients: fresh or fresh-frozen material, a current to carry it, and judicious use. The idea is to create a line of food that draws fish from far away. Toss in too much food over a short period of time, and the fish may hang too far back and simply enjoy a free lunch. Too little chum may not move them at all. Start slowly and gradually increase the chum until you get results.

How to Release
Use wet hands, a wet soft towel, or a wet cotton glove to release fish. Use long-nose pliers or some other device designed for hook removal wherever possible. If the hook is in a location where removal would require too much time or cause injury to the fish, cut the leader as short as possible and put the fish in the water as quickly as you can.

The Best Striking Motion
The best striking motion is sideways, not up. Sweep the rod smartly to the side until you feel the line come tight, and then hold firm pressure until the fish begins to take line.

Rinse Your Rod and Reel
Thoroughly rinse your rod and reel with fresh water immediately after fishing the salt. A gentle wash will do the job better than a hard spray. Make sure you pay close attention to the metallic frames of the rod guides; they are thin and can be easily damaged by corrosion if not properly cleaned.

[url "http://www.fieldandstream.com/fieldstream/fishing/saltwater/article/0,13199,192574,00.html#"][/url] [url "http://www.fieldandstream.com/fieldstream/fishing/saltwater/article/0,13199,192574,00.html#"][/url] [url "http://www.fieldandstream.com/fieldstream/fishing/saltwater/article/0,13199,192574,00.html#top"][/url]
[signature]
Reply
#2
sorry tubeN2, i have to disagree with you on a couple of topics. #1, "Fish bite best on lures that look new and bright."
i have an old Tady 45 and a Tady C in my tackle box that have most of the paint chipped away. it is almost bare metal! these jigs have caught the most fish for me. Bass, Barracuda, Yellowtail, and anything else you can think of, these jigs will catch it.

i believe that color is NOT as important as how the jig swims. the better the jig swims, the better it will get bit.

#2 "Setting the hook". sometimes it is not necessary to set the hook. sometimes it is WRONG to set the hook. the only time that i set the hook is when im yellowtail fishing. when yellowtail fishing, let the fish run with your bait for a good 5 seconds.
now when bass or barracuda fishing, i dont set the hook, i simply turn the handle faster.

#3 when tying a wire leader to mono, using an albright knot will definatly weaken the mono. i dont know if you have ever tyed an albright knot, but it involves ALOT of twisting. twisting that wire would not be able to do. and when sinching down the knot, the wire is sure to slice into the mono.

just my 2 cents.



joe
[signature]
Reply
#3
Hey DH tubinjoe, thanks for your well respected input. This was only from an article that I found and wanted to share with the rest of the world. It is obvious that there are different strokes for different folks. I'm glad you were able to spot some differences in the post. I too, have some differences in opinion from some of the material in the post.

Tight Lines Buddy.
[signature]
Reply
#4
ya know, i think that it all just depends on what type of fishing you are doing, and which part of the world you are fishing in. so what is on your post is probably quite accurate, just not in southern california.

i DID learn some things off of your post. thanks



joe
[signature]
Reply
#5
I'm glad that it was informative. I also have some different techniques that I have adapted over the years. I started in SoCal, went to Idaho, Utah, and to Northern Cal. Finally back down here since early 1980s. That is alot of adapting to do in different areas.

I learned some tricks that work in other areas that aren't practical her. And some of the stuff that we can do her is not legal in other states.

Have a good one Joe. Let me know how the fishing is going. I'm headed out to the CAT this weekend. Feel free to stop by and say hi if you are in the neighborhood.

Tight lines buddy.
[signature]
Reply


Forum Jump:


Users browsing this thread: 2 Guest(s)