02-25-2014, 12:43 AM
Here is the Bravo 2 Valve that is on the Predator.
![[Image: Valve3_zps50283b2d.jpg]](http://i44.photobucket.com/albums/f17/FlyGoddess/Predator/Valve3_zps50283b2d.jpg)
It is a push in and turn clockwise to open, reverse to close.
Here is the 2" chunk of hose
![[Image: Valve2_zpsf935ac75.jpg]](http://i44.photobucket.com/albums/f17/FlyGoddess/Predator/Valve2_zpsf935ac75.jpg)
I do not have a pump like yours but it goes on whatever fitting will fit into the hose. If you need to tape it on the pump, so be it.
It is HARD to get it into the valve. Put in boiling water to soften it or put it in the freezer to shrink it, it is tuff, but it does fit. And quite snug.
![[Image: Valve1_zpsa6e91f11.jpg]](http://i44.photobucket.com/albums/f17/FlyGoddess/Predator/Valve1_zpsa6e91f11.jpg)
It is HARD to pump in the closed position, but very doable. Fill as full as you can in open, then quickly close and top off. If you can leave to tube in the Valve and change out the pumps, this would help. Plus you should be able to stick your finger in the tube and twist the valve close. Would loose very little air this way.
[signature]
It is a push in and turn clockwise to open, reverse to close.
Here is the 2" chunk of hose
I do not have a pump like yours but it goes on whatever fitting will fit into the hose. If you need to tape it on the pump, so be it.
It is HARD to get it into the valve. Put in boiling water to soften it or put it in the freezer to shrink it, it is tuff, but it does fit. And quite snug.
It is HARD to pump in the closed position, but very doable. Fill as full as you can in open, then quickly close and top off. If you can leave to tube in the Valve and change out the pumps, this would help. Plus you should be able to stick your finger in the tube and twist the valve close. Would loose very little air this way.
[signature]